Table of Contents
Advertisement
THERM CONNECT
03
WOLF run around coil systems
Attention!
Only qualified personnel may work on electrical components. The local Energy Supply Companies (german: EVU)
regulations and Association of Electrical, Electronic & Information Technologies (german: VDE) regulations must be
observed.
No changes or additions may be made to the unit, otherwise the manufacturer's declaration of conformity will
become invalid!The WRG equipment can be a life-threatening source of danger due to rotating machine parts and
the risk of electric shock. Failure to observe the following safety instructions will result in DANGER FROM ELECTRI-
CAL SHOCK.
• The equipment contains high voltage capacitors that require a period of time to discharge after the main
power supply is interrupted.
• Make sure the hydraulic unit is disconnected from the power supply before performing any work.
Wait at least three minutes for the inverter to discharge to a safe voltage.
• Always disconnect the inverter from the circuit under test before performing a high voltage resistance test
on that circuit.
Symbols:
Opposite symbol is indicated in the operating instruc-
tions at any place where in case of non-observance
• there is danger to life and limb of persons
• damages of the machine can occur.
Opposite symbol is indicated in the operating
instructions at any place where there is danger
from electric components.
You find this symbol anywhere in these operating
instructions wherever there is a risk or need for incre-
ased protective measures due to areas at risk from
explosions.
You will find this symbol anywhere in these operating
instructions where there is a crushing hazard.
You will find this symbol anywhere in these operating
instructions where there is a suspended load hazard.
Warning against harmful and irritant substances
Opposite symbol in the operating instructions indicates
guidelines or cross-references which are important for
the operation of the RLT-plant.
Opposite symbol in the operating instructions indi-
cates information or application tips.
You will see the adjacent symbol anywhere, where
for example a risk of ignition can arise as a result of
electrostatic charge. The operator must earth (equi-
potential bonding) the entire unit according to state
of the art in order to prevent electrostatic charging.
5
Advertisement
Table of Contents
