United States; Canada; Mexico - Brady M211 User Manual

United States

Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including interference that may cause undesired operation.
Co-located statements: To comply with FCC RF exposure compliance requirement, the antenna
used for this transmitter must not be co-located or operating in conjunction with any other
transmitter/antenna except those already with radio module filing.
RF exposure guidelines: The radiated output power of this device is far below the radio frequency
exposure limits. Nevertheless, to avoid the possibility of exceeding radio frequency exposure limits for
an uncontrolled environment, a minimum 20cm distance should be maintained from Bluetooth radio
module PCB antenna (internal) to the head, neck, or body during normal operation.

Canada

Innovation, Science and Economic Development (ISED)
CAN ICES-3 (A)/NMB-3(A)
This device complies with Industry Canada's license-exempt RSSs. Operation is subject to the
following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
Co-located statements: To comply with FCC RF exposure compliance requirement, the antenna
used for this transmitter must not be co-located or operating in conjunction with any other
transmitter/antenna except those already with radio module filing.
RF exposure guidelines / Important note: This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.

Mexico

IFT notice:
M211 User Manual
Regulatory Compliance
Wireless Regulatory Information
32