Table of Contents
Advertisement
Message
Cause
Wrong PIN code
Wrong PIN code has been entered. Five at-
tempts are permitted, and the keypad is then
blocked for a period of time.
No drive
The product has got caught in something and
has been slipping.
Slipped
The work area includes a steep slope.
The guide wire is not laid diagonally in the
slope.
Collision sensor
The drive wheels on the product are blocked. Free the product and correct the cause of
problem, front/rear
Alarm! Mower switch-
The alarm is activated because the product
ed off
had been switched off.
Alarm! Mower stop-
The alarm is activated because the product
ped
has been stopped.
Alarm! Mower lifted
The alarm is activated because the product
has been lifted.
Alarm! Mower tilted
The alarm is activated because the product
has been tilted.
Alarm! Mower was
The alarm is activated because the product
moved
has been lifted.
Charging station
The contact between the charging plates on
blocked
the product on the and contact plates on
the charging station may be poor and the
product has made a number of attempts to
charge.
An object is in the way of the product that
prevents it to enter the charging station.
The charging station is tilted or bent.
The guide wire is not installed correctly.
Stuck in charging sta-
There is an object in the way of the product
tion
preventing it from leaving the charging sta-
tion.
Charging system
Incorrect type of battery.
problem
Charging current too
Wrong or faulty power supply unit.
high
38 - Troubleshooting
Action
Enter the correct PIN code. If the PIN code is
incorrect, use the link in the app to send the
PIN code to your registered e-mail address.
If you have not registered the e-mail address,
contact your local Husqvarna representative.
Free the product and rectify the reason for
the lack of drive. If it is due to wet grass,
wait until the lawn has dried before using the
product.
Steep slopes should be isolated. Refer to
put the boundary wire in a slope on page 15 .
Make sure that the guide wire is installed di-
agonally across the slope. Refer to
a secondary area on page 16 .
problem. If the problem stays, speak to your
authorized service technichian.
Adjust the security level in the
To set the security level on
menu. Refer to
page 23 .
Put the product in the charging station and
check that the charging plates and contact
plates make good contact.
Remove the object.
Put the baseplate on level ground.
Check if the guide wire is installed accord-
ing to the instructions. Refer to
guide wire on page 19 .
Remove the object.
Use original batteries recommended by the
manufacturer.
Restart the product. If the problem stays
speak to your authorized service technician.
1462 - 007 - 14.03.2022
To
To make
Security
To install the
Advertisement
Table of Contents
