Table of Contents
Advertisement
Message
Cause
Wheel motor
Grass or other object is wrapped around the
blocked, left/right
drive wheel.
Wheel motor overloa-
ded, left/right
Wheel drive problem,
right/left
Cutting system
Grass or other object is wrapped around the
blocked
drive wheel.
The blade disc lies in a pool of water.
The grass is too high.
Cutting system imbal-
Too few or too many blades.
ance
Outside working area The boundary wire connections to the charg-
ing station are crossed.
The boundary wire is too close to the edge of
the work area.
The work area slopes too much by the boun-
dary loop.
The boundary wire is laid in the wrong direc-
tion around an island.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
The product finds it hard to distinguish the
signal from another product installation close
by.
Empty battery
The product cannot find the charging station.
The battery is spent.
The charging station's antenna is defective.
The charging plates on the product or con-
tact plates on the charging station are corro-
ded.
Battery problem
Temporary battery or firmware related issue
in the product.
Incorrect type of battery.
Battery temperature
The temperature in the battery is too high or
outside limits
too low to start operation.
1462 - 007 - 14.03.2022
Action
Clean the wheels and around the wheels.
Clean the wheels and around the wheels.
Move the product and prevent the collection
of water in the work area.
Cut the grass before you install the product.
Make sure that the grass is maximum 10
cm / 3.9 in.
Do a check of the blades on the blade disc.
Check that the boundary wire is connected
correctly.
Check that the boundary wire has been laid
according to the instructions. Refer to
amine where to put the boundary wire on
page 14 .
Try moving the boundary wire.
Put the product in the charging station and
generate a new loop signal.
Change the position of the guide wire. Refer
To install the guide wire on page 19 .
to
Replace the battery. Refer to
page 35 .
Check if the indicator lamp in the charging
station flashes red. Refer to
Indicator lamp in
the charging station on page 41 .
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your authorized service technician.
Restart the product. If the problem stays
speak to your authorized service technician.
Use original batteries recommended by the
manufacturer.
No action. The product will start to operate
when the temperature is in limits.
Troubleshooting - 37
To ex-
Battery on
Advertisement
Table of Contents
