Mounting The Camera - JVC VN-V25U VN-V26U Instructions Manual

Mounting the Camera

Use the screw hole on the camera mounting
bracket to mount this camera to a fixer or
rotating platform.
Camera
Mounting
Camera Mounting
Screw Hole
Bracket Fastening Screw
1/4-20UNC
(2 pcs: M2.6 x 6 mm)
Anti-rotation Hole
Camera
Mounting
Bracket
Fall
Prevention
Wire
M3x6 mm
(15/64 inch)
6 mm
2 mm and below
Mounting the camera mounting
bracket on the top of the camera
Camera
Mounting
Bracket
Caution:
● When mounting the camera, use screws with
a length between 5 mm to 7 mm from the
mounting surface. Screws beyond the
specified length may damage the interior,
while those shorter than specified may cause
the camera to fall off, and therefore these
must not be used.
5 mm and
above
7 mm and
below
Caution:
● The camera mounting bracket is mounted on
the bottom surface of the camera by default.
To mount it to the top surface, do so by
removing the two fastening screws from the
camera mounting bracket. Make sure to
fasten the screws firmly.
1/4-20UNC
21