Frigidaire FHPC102AC1 Use & Care Manual page 9

1. Extend either side of the hose(Fig.1).
Extend the side of hose
2. Install the connector B into the unit
(Fig.2).
2
Lock
Fig.2
3. A x the connector A into the window
slider kit and seal.(Fig.3&4)
Vertical
window
Window Slider Kit
Minimum:26.6(67.5cm)
Maxmum:52.5(133cm)
Horizontal
window
Window Slider Kit
Minimum:26.6(67.5cm)
Maxmum:52.5(133cm)
INSTALLATION INSTRUCTIONS
Fig.1A
1
Slide onto
Fig.3
Fig.4
The hose can be extended from its original
length of 15" up to 59", but try to maintain
the minimum required length. Also make
sure that the hose does not have any sharp
bends or sags.(Fig.5)
Installation in a double-hung sash
window
1.Cut the adhesive foam seals (A) to the
proper lengths and attach them to the
window and sill.(Fig.6)
2.Open the window sash and place the
window slider kit on the window sill (Fig.7).
Attach the window slider kit to the window
sill. Adjust the length of the window slider
kit according to the width of window. Screw
down the two screws on the window slider
kit. See Fig.7.
Cut the adjustable window slider kit if the
width of window is less than 26.6
inches(Fig.8).
screws
26.6"~52.5"
window sill
9
Fig.5
Foam seal A
(adhesive type)
Fig.6
Window slider kit
Fig.7