Frigidaire FHPC102AC1 Use & Care Manual page 22

22
OPERATING INSTRUCTIONS
Figure 22
• Insert the rubber head into the outlet. Then
screw the sealing cap into the heat pump
drain outlet(Fig.23).
1
heat pump
drain outlet rubber head sealing cap
Figure 23
• Lead the other end of the 1/4" drainage
hose to a drain that is not 16ft(5m) higher
than the heat pump drain outlet.
Note:
There is a 1/4" hole on the window kit for
leading the drainage hose outside during the
heating mode.
Do not drain condensate outside when
outside temperature is below 32°F (0°C).
Heat pump
drain cap
2
Window slider kit
1/4" hole
Figure 24
Emptying the condensate residue inside
the unit during winter storage.
Put a drip tray (not supplied) under the
continuous drain outlet, then unscrew the
drain cap to allow the condensate to flow
into the drip tray. Replace the drain cap to
the continuous drain outlet when no
condensate flows out.
Put the drip tray under the bottom drain
outlet, then remove the rubber stopper from
the drain outlet, to allow the condensate to
flow into the drip tray. If your drip tray can't
hold all the condensate, a number of fills will
be needed.
Replace the drain cap to the bottom drain
outlet when no condensate flows out.
Note: To ensure all condensate residue has
been removed, tilt the unit by lifting it
slightly upwards from the front until no
more condensate comes out from the drain
outlet.
Figure 25
Bottom
Drain Outlet
Drain cap
Drip tray