Frigidaire FHPC102AC1 Use & Care Manual page 10

10
INSTALLATION INSTRUCTIONS
Cut this to fit your window
3.Close the window sash securely against
the window slider kit.(Fig.9)
4.Drive two 1/2" screws to secure the
window slider kit to the window sash.(Fig.9)
5.Secure the window slider kit to the
window sill(Fig.9):
A: For wooden window: Use 3/4" screws for
securing.
B: For Vinyl-Clad windows: Use 1/2" hex
head cap screws for securing.
1/2"screws
3/4" screws or 1/2"
hex head cap screws
window sill
6.To secure lower sash in place, attach right
angle sash lock with 1/2" (12.7mm) screw as
shown(Fig.10).
Fig.8
Window slider kit
Fig.9
Fig.10
7.Cut the non-adhesive foam seal (B) to an
appropriate length and seal the open gap
between the top window sash and outer
window sash, as shown in Fig.11.
Foam seal B
Installation in a sliding sash window
1.Cut the adhesive foam seals (A) to the
proper lengths and attach them to the
window frame. See Fig.12.
Foam seal A
(adhesive type)
2.Open the window sash and place the
window slider kit on the window sill (Fig.13).
Attach the window slider kit to the window
sill. Adjust the length of the window slider
kit according to the height of window.
Screw down the two screws on the window
slider kit. See Fig.13.
Cut the adjustable window slider kit if the
height of window is less than 26.6
inches(Fig.8).
window sill
26.6"~52.5"
Fig.11
Fig.12
Window slider kit
screws
Fig.13