Table of Contents
Advertisement
has been triggered, a 0 is displayed if
the glass surface temperature is not
dangerous for the user or an H if there
is a burn risk.
To reconnect the appliance, switch it
then switch it on again.
In case of operating problems
service.
good use of vitroceramic
* Use pots or pans with thick,
* Pans with a smaller diameter than
the shown heating area are not
recommended.
* Do not slide pots and pans over the
glass as they may scratch it.
* Although the glass can withstand
knocks from large pots and pans
without sharp edges, try not to
knock it.
* To prevent damage to the ceramic
glass induction surface, try not
to slide the pots and pans over
the glass, and keep the bottoms
of the vessels clean and in good
condition.
Try not to spill sugar or
Cleaning and maintenance
To keep the appliance in good
condition, clean it using suitable
products and implements once it has
cooled down. This will make the job
easier and avoid the build-up of dirt
Never use harsh cleaning products or
tools that could scratch the surface, or
steam-operated equipment.
A pot or pan may become
glass break.
(1) and
lean on it as it could break and
SMEG reserves the right to make
changes to its manuals that it deems
the product's essential features.
Environmental
considerations
product cannot be treated like
product must be taken to a recycling
collection point for electrical and
electronic appliances. By ensuring
detailed information about recycling
environmentally-friendly and can
be recycled completely. Plastic
your local container.
Before calling the technical service,
perform the verifications specified
below.
Ensure that the power cable is plugged
in.
If there is molten material between
the pot and the glass, set the hot
plate to maximum power and try to
separate them.
Single Sensor Error :
If any of the sensors is active more
than 10 seconds, this error situation
occurs and error code"F1" is showed.
roots. One of them is that there may
be an object (fork, knife...) on the any
of the sensor.
Make sure that there is no any object
on the control unit, hob glass is wiped
with a dry cloth. If error situation
continue after this solution, please
for 10 second.
Plural Sensor Error:
If more than 2 sensors are sensed at
same time, this error situation occurs
and error code"F2" is displayed.
problem :
• There may be an object(pot...) or
from pot...) that cover more than 2
sensors
• Touch control location may
exposure more heat or steam
(from oven bottom of the hob...)
Please be sure that there is no any
all steam and heat sources. Then,hob
glass is wiped with a dry cloth. If error
situation continue after this solution,
switch for 10 second.
FC Error:
Fc message on the control and the
hot plates switch off: Overheating
in the electronics. Let thestove cool
for a while.
EN
33
Advertisement
Table of Contents
