Table of Contents
Advertisement
Installation
INSTALLATION AND SETUP SHOULD BE CARRIED
OUT BY AN AUTHORISED TECHNICIAN IN LINE WITH
CURRENT INSTALLATION STANDARDS.
To install these models, an opening with the dimensions
The worktop fastening system is suitable for units 20, 30
and 40 mm thick.
The minimum distance between the surface supporting
the cooking pans and the lower part of the kitchen unit or
the hood located above the hob should be 650 mm. If the
hood's installation instructions recommend that the gap is
greater than this, you should follow this advice.
The unit where the hob and oven will be located will be
INSTALLATION WITH CUTLERY DRAWER OR LOWER
CABINET
In mixed induction - vitroceramic hobs, if you would like
to have a cabinet or a cutlery drawer under the hob, it is
necessary to put a separation board in between the two.
The board should be situated 20 mm below the underside
of the hob, leaving a free space of at least 20 mm until the
This prevents accidental contact with the hot surface of
the casing of the heating elements under the apparatus
er.
INSTALLATION WITH FAN OVEN UNDER THE HOB
The oven should be installed according to the correspond-
ing manual.
An opening of 20 mm should be made in the back part of
Minimum distance
Minimum ventilation
distances
SE232TD1 - SE232TX1
-
EN
fig. 1
27
Advertisement
Table of Contents
