Table of Contents
Advertisement
16 installation instructions electrolux front loading washing machine
Installation instructions continued
Water drainage
The end of the drain hose can be positioned in three ways:
•
Hooked over the edge of a sink using the plastic hose
guide supplied with the appliance. In this case, make
sure the end cannot come unhooked when the machine
is emptying.
This could be done by tying it to the tap with a piece of
string or attaching it to the wall.
•
In a sink drain pipe branch. This branch must be above
the trap so that the bend is at least 60cm above the
ground.
•
Directly into a drain pipe at a height of not
less than 60cm and not more than 90cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside
diameter of the drain hose.
The drain hose must not be kinked.
Electrical connection
Information on the electrical connection is given on the
rating plate on the inner side of the appliance door.
Check that your domestic electrical installation can take the
maximum load required, also taking into account any other
appliances in use.
warning
Connect the appliance to an earthed socket.
The manufacturer declines any responsibility for
damage or injury through failure to comply with the
above safety precaution.
Should the appliance power supply cable need to be
replaced, this should be carried out by our Service
Centre.
NOTE: Please ensure that when the appliance is installed
it is easily accessible for the engineer in the event of a
breakdown
caution
If this appliance is supplied from a cord extension set
or electrical portable outlet device, the cord extension
set or electrical portable device must be positioned
so that it is not subject to splashing or ingress of
moisture.
Advertisement
Table of Contents
