Water Drainage - Electrolux EW 1548 F Installation And Instruction Manual

Water drainage
The end of the drain hose can be positioned in three
ways:
Over the edge of a basin: in this case you must
ensure that the hose cannot move when the water
is drained. Secure it to the wall with a hook, for
example, or to the tap by means of a piece of string.
In a basin drainpipe branch: the branch must be
above the basin siphon so that the end of the hose
is at least 60 cm from ground level.
Directly in a drainpipe: you are advised to use a
vertical 65 cm high pipe; in any case it should never
be shorter than 60 cm or longer than 90 cm.
The end part of the drain hose must always be
ventilated, i.e. the internal diameter of the pipe must
be wider than the external diameter of the drain
hose.
The drain hose can be extended up to a maximum
length of 180 cm. Use an extension with an internal
diameter at least equal to the diameter of the
original hose and a suitable fitting. The hose
extension will run along the floor and only the part
near the drainage point will be raised.
Kil
FT yat» Cn
||
Levelling
Position the appliance and level it by tightening or
loosening one or two of the adjustable feet. Ensure
that the machine is resting securely with all four
feet on the ground. Once the machine has been
levelled, tighten up the lock nuts on all four feet.