Erasing All Commands And Macros That Have Been Programmed; Macro Mode Programming Memo - Integra DTR-7.1 Owner's Manual

Using a Macro function
ON
AUDIO
TRACK
REC
DVD
T1 T2
V1 V2
STEREO DIRECT
1 2
SURROUND THX
4 5
Re-EQ CH SEL
7 8
LATE NIGHT DIMMER
+ 10
0
HOME THEATER CONTROLLER
RC-418M

Macro mode programming memo:

MACRO MODE
MACRO MACRO
↓
AUDIO
Operation 1
Operation 2
Operation 3
Operation 4
Operation 5
Operation 6
Operation 7
Operation 8
Operation 9
Operation 10
Operation 11
Operation 12
Operation 13
Operation 14
Operation 15
Operation 16
STNBY
MUTING
DISC
OPEN/CLOSE
CD
TUN PH
V3 V –
DSP
3
DSP
6
LEVEL +
9
LEVEL –
ENT
ENT
MODE MODE MODE
MACRO MACRO
↓ ↓ ↓
CD DVD MD
Erasing all commands and macros that have
been programmed
This procedure will erase all the commands and macros that you
have programmed into the remote controller and return it to its
default settings. This operation will not affect the preset settings of
the remote controller.
1. Open the battery cover and remove the
batteries from the remote controller.
2. While pressing and holding down the ON and
STNBY buttons, re-insert the batteries in their
correct orientation, and then release both
buttons.
The SEND/LEARN indicator flashes slowly and "CLEAR"
appears in the display.
3. Press the ENT button.
The SEND/LEARN indicator lights up for about ten seconds
and then turns off and "AUDIO" appears in the display.
All programmed commands and macros are erased and the remote
controller returns to its factory presets.
Notes:
• Proceed to Step 3 immediately after Step 2; otherwise, the
batteries will be consumed quickly.
• If you press any button other than the ENT button in Step 3,
nothing will be erased. In this case, resume from Step 1.
MODE MODE MODE
MACRO MACRO MACRO
↓ ↓ ↓
SAT CABLE VCR
MODE DIRECT
MACRO MACRO
↓
TV
67