Integra DTR-7 Instruction Manual page 28

Selecting an input source
1
DVD VIDEO-1 VIDEO-2 VIDEO-3
2
DIGITAL/
ANALOG
PRESET/MODE ADJ
PUSH TO ENTER
3
PRESET/MODE ADJ
PUSH TO ENTER
4
PRESET/MODE ADJ
PUSH TO ENTER
28
VIDEO-4 TAPE FM AM PHONO
SPEAKERS TUNED
A
SPEAKERS TUNED
A
SPEAKERS TUNED
A
Setting the input signal format
The input signal format defaults to "Automatic." Although you can
C D
use this default setting normally, you may change it depending on
the input signal format.
Ex.) Setting the input signal format for DVD
1. Press the DVD input selector button.
2. Press the DIGITAL/ANALOG button twice to display the
digital input format.
Press the SMART SCAN CONTROLLER.
AUTO
You are now able to select the input signal format.
3. By rotating the SMART SCAN CONTROLLER, select the
input signal format from among "Automatic," "Digital,"
"Analog," "PCM," and "DTS."
Automatic (Automatic detection)
Input signal format (Dolby Digital, DTS, or PCM) used in the
AUTO
selected input source is detected automatically to execute the
required decoding process. If no digital signal is input, the input
signals to the analog input jacks will be played.
Digital (Digital input automatic detection)
Input digital signal format (Dolby Digital, DTS, or PCM) used
in the selected digital input source is detected automatically to
execute the necessary decoding process.
AUTO
Analog (Analog audio signal processing)
The audio signals input from the equipment connected to the
analog input jacks are played.
PCM (PCM signal processing)
A decoding process is executed only when PCM signals are in-
put.
DTS (DTS signal processing)
A decoding process is executed only when DTS signals are in-
put.
Notes:
• In "Automatic" or "Digital" mode, if the CD or LD is fast-for-
warded during playback, decoded PCM signals may produce
skipped sound. In such cases, change the digital audio format to
"PCM."
• If a CD or LD encoded in the DTS format is played back using
"PCM" or "Analog" mode, a noise will be produced. This noise
could damage the amplifier and speakers. Always use "Auto-
matic", "Digital", or " DTS" mode when playing back DTS-en-
coded sources.
4. Press the SMART SCAN CONTROLLER.
This completes the digital audio format setup.
(Digital Input Setup)