Integra DTR-7 Instruction Manual page 27

Selecting an input source
1 This button allows you to set the sleep timer.
(See page 31.)
2 Press this button to set the mode in which you can operate the
DTR-7/6.
3 Use this button to change the brightness of the display (normal
or dim).
4 You can connect stereo headphones to the PHONES jack using
a standard stereo plug.
(When you connect headphones, the unit will enter STEREO
mode automatically and no sound will be heard from the speakers.)
3
** Input Selector **
Input
Digital Input Setup
Video Assign Setup
IntelliVolume Setup
Listening Dolby
Mode= Pro Logic
= DVD
OPTICAL 1
THX Cinema
2
. SP A
1 SLEEP
2 MODE AUDIO
4
. VOLUME /
1
. INPUT SELECTOR
3 DIMMER
If no sound is heard from the speakers, check the
following items:
• When you have selected DVD, CD, VIDEO 1- 3, or TAPE,
check the "digital input setup" is correct. (See page 23.)
• Make sure that the input signal format setting is correct. (See
page 28,29.)
• The Muting function may be activated. Cancel the Muting func-
tion. (See "Muting the sound" on page 31.)
• Make sure that SPEAKERS A is selected. (See "Selecting the
speaker system" on page 30.)
Warning:
• Do not play CD-ROM discs that contain computer data as they
may damage the speakers when the sound is amplified by the
receiver.
• Selecting an input source using the on-screen
display
Instead of using the input selector buttons, you can use on-screen
display to select the desired input source.
1. Press the OSD MENU button.
2. Select "Input Selector" and then press the right edge of the
ENTER/Cursor button.
3. Press the upper or lower edge of the ENTER/Cursor button
to select "Input" and then press the right or left edge of the
button to select an input source.
• When you select DVD, CD, VIDEO 1- 3, or TAPE, set the
digital input parameters on the Digital Input Setup screen.
(See page 29.)
• When you have selected TUNER, the currently selected pre-
set number is displayed on the next line.
• See page 33 for information on MULTICH INPUT.
4. Press the center of the ENTER/Cursor button, or press the
EXIT button, to exit the setup mode.
27