CAUTION: Never install the magnetron without the metallic gasket plate which is packed with each
magnetron to prevent microwave leakage. Whenever repair work is carried out on
magnetron, check the microwave leakage. It shall not exceed 4mW/cm2 for assembled
oven with door normally closed.
9. To remove fan motor assembly.
(1) Remove a screw (F03) holding the wind guide assembly.
(2) Remove fan (F07).
(3) Remove the screws (F04) holding the fan motor (F05).
(4) Reverse the above for reassembly.
10. To remove transformer.
(1) Remove the four screws (F23) holding the
transformer (F24).
(2) Remove the transformer (F24).
(3) Reverse the above steps for reassembly.
29