Connecting Your Monitor - IBM 6736-HB0 User Manual

Connecting your Monitor

Be sure to read the 'Safety'
Information located in the
Monitor Safety and Warranty
Information Manual before
carrying out this procedure.
1. Turn off your computer and all attached devices. Next, unplug the
power cord(s) to your computer and all attached devices.
2. Connect the signal cable.
The analog signal cable is already connected to your monitor.
analog connector is the blue connector.
When connecting the analog signal cable (Figure A)
Connect the free end of the attached signal cable to the 15-pin Monitor
port on the computer and tighten screws.
If connecting a DVI-D digital signal cable (Figure B)
Connect one end of the monitor signal cable to the white connector
on the rear panel of the monitor. Connect the other end to the white
connector on the rear panel of the computer and tighten the screws.
A
(Figure A)
(Figure B)
The
Cable not supplied
(Optional)
7