Manual Image Setup - IBM 6736-HB0 User Manual

Manual Image Setup

i
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
Normally, you can complete the setup procedure using Automatic Image S
however, if your screen image is still distorted after you perform Image S
the setup CD does not run on your system, perform M
To manually adjust the image setting, do the following:
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button
the initial OSD menu.
4. Use the Right Arrow button(
and press the OSD Enter button
5. Use the Right Arrow button(
button ( )twice to select COLOK.
6. Use the Arrow buttons to manually adjust to correct (as much as
possible) for jitter or noise in the image. Press OK button(
7. Press OK( ) and use Arrow buttons to adjust PHASE, press OK(
Press OK( ) again to Save and Exit. Then press Cancel button(
twice to exit OSD.
You have completed the monitor setup.
ANUAL
at the bottom of the monitor to display
) to select the IMAGE SETUP icon
to access the function.
), to select to MANUAL. Press the OK
etup;
or
etup
I S .
MAGE ETUP
).
).
)
15