Table of Contents
Advertisement
T55D.book Page 8 Monday, August 31, 1998 5:46 PM
Connecting your Monitor
Be sure to read the
'Safety Information' at
the front of this User Guide
before carrying out this
procedure.
The AC adapter and Plug-
and -Display signal cable
are connected to your monitor. If
you wish to change these or to fit
a different stand, see Further
Help on page 22.
The smaller port next to
the P&D port is used for
analog monitors.
8
1.
Turn off your PC and all attached devices.
2.
Connect the Plug-and-Display (P&D) connector at the end of the signal
cable to the P&D port located on the back of the graphics adapter.
3.
4.
Connect the power cord to the power adapter first, then insert the plug
into a properly grounded electrical outlet.
5.
Switch on the power source and your computer. To turn on the monitor,
push and release the power switch
the power switch again.
Now, continue with Software Installation on page 9.
graphics adapter
Plug-and-Display
Signal Cable
. To switch it off, push and release
Advertisement
Table of Contents
