Maintenance; Criteria For Maintenance; Safety Measures To Be Adopted; Tightening Torque Settings - Stiga 2021 Edition PARK 320 P Workshop Manual

WORKSHOP MANUAL

2.5.1 Criteria for maintenance

The Instruction Handbook has a number of operations to be carried out by the Customer for a
minimum of basic maintenance, and other operations not always within his capacity.
For this reason the Service Centre should undertake to keep the machine in perfect working order
adopting a routine maintenance schedule.

2.5.2 Safety measures to be adopted

All the machines are manufactured in accordance with the strict European safety regulations in
force. To maintain these levels of safety in the longer term, the Service Centres should work to this
end by making appropriate checks every time there is the chance to do so.
In particular, every time there is work done on the machine the Service Centre should:
● check:
- the correct functioning of the safety devices;
- that the casings and protection covers have not been removed;
- that the labels with instructions or provisions have not been removed or have become illegible
(these form an integral part of the safety system).
● and also:
- restore to proper working order any safety devices which have been manipulated or removed;
- reassemble inefficient, damaged or missing casings and protection covers;
- replace illegible labels;
- clean the inside of the cutting deck (if assembled) with water and a non-metal bristle brush;
- touch up the painted parts where the paint is scratched or missing;
- not endorse any repair or modification on the machine or the engine which results in a change in
performance or use that is incorrect or different from the purpose for which it was designed and
approved;
- warn the Customer that failure to comply with the above points automatically voids the warranty
and the responsibility of the Manufacturer.

2.5.3 Tightening torque settings

The table shows the standard tightening torque settings for screws and nuts to be applied ac-
cording to their size, except for different situations indicated in the manual regarding a specific
procedure.
Thread
Tightening torque
PARK 2 - INFORMATION FOR SERVICE CENTRES

2.5 MAINTENANCE

M5
6 Nm
Chapter
M6 M8
10 Nm 24 Nm
EDITION PAGE
2020 15 /
124
M10 M12
47 Nm 84 Nm