Sony MDS-E10 Service Manual page 47

3-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
1) Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.)
2) Turn the l AMS L knob and display "CPLAY 1 MODE" (C34).
3) Press the YES button to change the display to "CPLAY 1 MID".
4) When access completes, the display changes to "C =
Note: The numbers " " displayed show you error rates and "ADER".
2. Changing the parts to be played back
1) Press the YES button during continuous playback to change the display as below. The parts to be played back can be moved.
"CPLAY 1 MID" t "CPLAY 1 OUT" t "CPLAY 1 IN"
2) When access completes, the display changes to "C =
Note: The numbers " " displayed show you error rates and "ADER".
3. Ending the continuous playback mode
1) Press the MENU/NO button. The display will change to "CPLAY 1 MODE".
Press the EJECT A button and take out the disc.
2)
Note: The playback start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
3-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check.)
1. Entering the continuous recording mode
1) Set a recordable disc in the unit.
Turn the l AMS L knob and display "CREC 1 MODE" (C34).
2)
3) Press the YES button to change the display to "CREC 1 MID".
4) When access completes, the display changes to "CREC 1 (
Note: The numbers " " displayed shows you the recording position addresses.
2. Changing the parts to be recorded
1) When the YES button is pressed during continuous recording, the display changes as below. The parts to be recorded can be changed.
" " goes off during movement.
REC
"CPLAY 1 MID" t "CPLAY 1 OUT" t "CREC 1 IN"
2) When access completes, the display changes to "CREC 1 (
Note: The numbers " " displayed shows you the recording position addresses.
3. Ending the continuous recording mode
1) Press the MENU/NO button. The display changes to "CREC 1 MODE" and "
Press the EJECT A button and take out the disc.
2)
Note 1: The recording start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
Note 2: The MENU/NO button can be used to stop recording anytime.
Note 3: Do not perform continuous recording for long periods of time above 5 minutes.
Note 4: During continuous recording, be careful not to apply vibration.
AD = ".
AD = ".
" and " " lights up.
REC
" and " " lights up.
REC
REC " goes off.
— 47 —