Table of Contents
Advertisement
B. Remove the HAMMER UNIT
B-1. Place the chassis upside down so that the hammers are visible.
B-2. Press the chassis with the tip of tweezers.
B-3. While catching a hammer with tweezers, set the tweezers against the resin part of the chassis.
B-4. Using the chassis-tweezer contact as a fulcrum point, press down against the resin part in the
direction of the red arrow in the illustration below, and then disengage the hammer.
[NOTE] You must press the resin part of the hammer.
[NOTE] Pressing on the metal part of the hammer may damage the area connected to the resin.
Fulcrum point
Tweezers
Press down the resin part.
– 20 –
CDP-130
Hide quick links:
Advertisement
Table of Contents
