Mounting the PC Card Unit
4-3-6 Setting the Operating Level
Operating Level (Pin 1)
4-4
Mounting the PC Card Unit
Pin 1 is used to set the PC Card Unit operating level. The procedure and pin set-
tings are described below.
Pin 1 setting
OFF
ON
If the SYSMAC LINK Unit or SYSMAC NET Link Unit is to be used together with a
PC Card Unit, select a different level.
Note Do not switch the operating level while the PC Card Unit is operating. Otherwise,
the Unit will fail to operate normally.
This section describes how to mount the PC Card Unit on the CPU Backplane.
Note Before mounting the PC Card Unit on a CPU Backplane, always mount the
C200HW-COM01 or C200HW-COM04-E Communications Board in the
C200HX/HG/HE. Refer to the C200HW-COM01 to 06-E Communications
Board Operation Manual for the mounting procedure.
Pin 1
Description
Level #1
Level #0
Section 4-4
33