Engine Oil; Engine Oil Filter; Changing The Engine Oil - Husqvarna MZ25 / 968999780 Operator's Manual

Engine Oil

4. Engine Oil Filter

• Drain the engine oil in accordance with the
work description under the heading Engine
Oil/Change Engine Oil.
• Remove the oil filter. If necessary, use a
filter remover.
• Wipe new, clean engine oil onto the seal
for the new filter.
• Mount the filter by hand with +¾ turn.
• Run the engine warm, then check that
there are no leaks around the oil filter seal.
• Check the oil level in the engine, fill
if necessary. The oil filter holds 0.1 qt (0.1
liters) of oil.
WARNING!
Engine oil can be very hot
if it is drained directly after
stopping the engine. Allow
the engine to cool to a safe
temperature first.

5. Changing the Engine Oil

The engine oil should be changed for the first time
after 5-8 hours of operation. Thereafter, it should be
changed every 50 hours. The oil drain valve is located
at the rear of the unit, to the right of the oil filter.
• Place the machine on a flat surface.
• Place a container under the engine where
the oil drain valve exits.
• Remove the valve cap.
• Allow the oil to run out into the container.
• Reinstall the oil drain valve cap.
• Replace the oil filter if necessary.
• Fill with new engine oil in accordance with
Checking the Oil level.
• Start the engine. Run it for 3-5 minutes. Stop
and recheck the oil level.
-52
English
lUBRICATION
Changing the oil filter
IMPORTANT INFORMATION
Used engine oil is a health hazard and
must not be disposed of on the ground or
in nature; it should always be disposed
of at a workshop or appropriate disposal
location.
Avoid skin contact; wash with soap and
water in case of spills.
Oil drain valve
8011-734