Lubricating The Cables; Front Wheel Mount; Front Wheel Bearings; Deck Spindle - Husqvarna MZ25 / 968999780 Operator's Manual

Lubricating the Cables

If possible, grease both ends of the cables and move
the controls to end stop positions when lubricating.
Refit the rubber covers on the cables after lubrication.
Cables with sheaths will bind if they are not lubricated
regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it
vertically. lubricate it with light engine oil until the oil
begins to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that
it seals against the sheath and allow the cable to hang
vertically from the bag overnight. If you do not succeed
in lubricating the cable, it must be replaced.

1. Front Wheel Mount

lubricate with a grease gun, one zerk for each wheel
mount, until the grease is forced out.
Use only good quality bearing grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.

2. Front Wheel Bearings

lubricate with a grease gun, one zerk for each set of
wheel bearings, until the grease is forced out.
Use only good quality bearing grease.

3. Deck spindle

lower the cutting deck completely.
If you use grease gun without rubber hose, the foot
plate must be removed.
lubricate with a grease gun, one zerk,
2-3 strokes.
Use only good quality bearing grease.
IMPORTANT INFORMATION
Use minimal lubrication and remove excess
lubricant so that is does not come into contact
with belts or belt pulley drive surfaces.
lUBRICATION
Lubricating the front wheels
Deck spindle
8011-731
8011-732
-51
English