Anti-Scalp Rollers - Husqvarna MZ25 / 968999780 Operator's Manual

4. Confirm measurements once again. Blade
tips should be level in a side-to-side manner.
In the rear, blade tips should be level to
higher than side-to-side measurement. In the
front, blade tips should be level to
than side-to-side measurement.
NOTE: This will place the mower deck in a base
measurement position. Additional adjustment may be
required to achieve desired cut for the type of grass or
conditions being mowed.

Anti-scalp rollers

Anti-scalp rollers are properly adjusted when they
are just slightly off of the ground when the deck is at
the desired cutting height in the operating position.
Anti-scalp rollers then keep the deck in the proper
position to help prevent scalping in most terrain
conditions.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower
on a flat level surface.
The anti-scalp rollers can be set in three positions:
•
Upper position 1½ to 3" (38 to 76 mm) grass.
•
Middle position 3" to 4½" (76 to 114 mm) grass.
•
lower position 4½" to 6" (114 to 152 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
IMPORTANT INFORMATION
The anti-scalp rollers must not be used
for gauge wheels or the roller and deck
may be damaged.
-48
English
MAINTENANCE
/ "
1
8
/ " lower
1
8
Anti-scalp rollers
CZ-9