3.
Remove the five screws to detach the front beam (T).
PSW3 x 6
Bosses
Front beam (T)
PSW3 x 6
Holes
PSW3 x 6
(a)
Note
• When installing the front beam (T), fit the four bosses with the four holes.
• When installing the front beam (T), tighten the screws in the order of (a), (b), (c), (d), (e).
4.
Remove the four screws from the HP-160A board.
PSW3 x 6
(d)
HP-160A board
PSW3 x 6
(a)
Note
• When installing the HP-160A board, push portions A of the board against the frame.
• When installing the HP-160A board, tighten the screws in the order of (a), (b), (c), (d).
5.
Remove the HP-160A board from the two connectors on the MB-1206 board.
PWS-4400
MEM PC board retainer
(c)
(d)
(e)
PSW3 x 6
(c)
Frame
PSW3 x 6
(b)
PSW3 x 6
Bosses
(b)
PSW3 x 6
Holes
Portions A
4-33