Table of Contents
Advertisement
4.
Disconnect the harness from the connector (CN6) on the PS-803 board.
PSW3 x 6
Power cover
5.
Remove the three screws and open the power cover block in the direction of the arrow.
6.
Disconnect the two harnesses (+12V GND) from the two connectors (CN1, CN2) on the CN-3300 board.
Power cover block
7.
Cut the two clamps.
8.
Remove the harness from the three mini clampers.
PWS-4400
PSW3 x 6
CN6 (PS-803 board)
Harness
PSW3 x 6
Harness (+12V GND) (Black)
Harness (+12V GND) (Orange)
PSW3 x 6
CN1 (CN-3300 board)
PSW3 x 6
CN2 (CN-3300 board)
CN-3300 board
4-8
Advertisement
Table of Contents
