Hunter 44033-01 44272 Owner's Manual page 30

Features
Menu Options
4. The next Menu option is to set your thermostat's primary span. Use
the or buttons to adjust between 1, 2, or, 3 degrees. Press
after this has been changed or if no changes are necessary. The span
setting regulates when and how long your system will run. The span
has been set at the factory to 1 which will allow the system to turn
on.5 F (.05
O O
(.05 C) above or below the set temperature.
O
Example: If your thermostat is set to turn on at 72
a span setting of 2, your thermostat will activate your furnace at 71
shut it down when it reaches 73
2, your air conditioner will activate at 73
setting can be changed to 1, 2, or 3. 1 will shorten your running time
while 3 will lengthen it.
5. Unless you have a multi-stage conventional or heat pump system,
there is no need to change the second stage span. If you do, use the
or buttons to adjust between 1, 2, or, 3 degrees. Press
this has been changed or if no changes are necessary. Secondary
span acts the same as your primary, but it determines when and how
long your second stage heat runs.
6. The last menu option changes your temperature readings between
Fahrenheit and Celcius. Use the
them and hit
different menu item, or
30
C) above or below the set temperature and run for .5
if you need to go back and make a change to a
Next
to be returned to the home screen.
Done/
Home
44033-01 • 05/11/2010
6
. For cooling at 72
O
and shut down at 71
O
or buttons to switch between
in heat mode, with
O
and
O
with a span of
O
. This
O
once
Next
Next
F
O