Table of Contents
Advertisement
10 • Installation and Setup of Maestro™ and Remote (Continued)
Powering the Maestro™:
10-1. Plug the AC adaptor into the back of the Maestro™ in the
port labeled power.
10-2. Select the correct channel by sliding the switch to the
desired channel.
For 3.5mm Stereo Cable Installation:
10-3. Plug a 3.5mm stereo cable into the back of the Maestro™
in the port labeled line in.
10-4. Plug the other end of the 3.5mm stereo cable into
your audio device.
For Speaker Wire Installation:
10-5. Connect the speaker wire (not included) to the speaker
input terminals on the bottom of the Maestro™. Make
sure that the plus (+) and the minus (-) signs on the
Maestro™ correspond with the plus (+) and the minus (-)
signs on your audio device.
10-6. Make sure that all connections are firm.
Contact between bare speaker wires at the terminals
NOTE:
can cause a short-circuit.
10-7. Install the included 3-volt battery into the transmitter
This product includes one 3-volt type CR2025 battery for
use with the remote control transmitter. Please contact
your local battery recycling center for proper battery
disposal information.
CAUTION: The remote control device complies with part 15 of the
FCC rules. Changes or modifications not expressly approved by Hunter Fan
Company could void your authority to operate this equipment.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
AC Adaptor
3.5mm Stereo
17
45049-01 • 07/13/09 • Hunter Fan Company
Maestro™
Cable
DO NOT put Maestro™ in a damp
place or where humidity is high.
NOTE: For Optimal Performance. Place
the Maestro™ at least 5' away from
all wireless devices.
Hide quick links:
Advertisement
Table of Contents
