Chapter 9. Installation Of Options - Sharp ER-A220 Service Manual

CHAPTER 9. INSTALLATION OF OPTIONS

1. REMOTE DRAWER: ER-05DW/06DW
CAUTION
Before turning the mode switch from the (SRV') to (SRV), make
sure the AC power cord is connected to the wall outlet;
otherwise, the data on memory might be destroyed.
1-1. Outline
The ER-A220 allows connection of one remote drawer ER-
05DW/06DW.
1-2. Installation procedure
1) Separating standard drawer
Remove the printer cover.
Remove the screws securing the drawer.
Pull the unit the direction indicated by the arrow and lift it up in
the direction of B.
1
Put the drawer upright at the left side of the unit and remove the
drawer connector.
2) Affix two rubber legs (GLEGG6659BHZZ) to the front
part of the lower cabinet.
3) Connect the remote drawer cable to the drawer
connector on the main PWB. (Location: CN10)
4) Use nippers to cut off drawer cable binding holder
B
2. KEY TOP KIT: ER-11KT7/12KT7/22KT7
A
2-1. ER-11KT7
on the bottom cabinet, and bind drawer cable.
Screw used in this case is an accessory of the
DRAWER UNIT.
DUMMY KEY KIT: ER-11DK7G/15DK7G
ER-22KT7
ER-12KT7
ER-11KT7