Getting Started; Battery Removal And Installation - VTech KidiGo NexTag Instruction Manual

5. Thread the tail of the Arm Band up through
the buckle.
6. Finally, pull the end of the Arm Band through
the other slot of the buckle and under the tab.
7. Now, you're ready to go!

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of
each unit, use a screwdriver to loosen
the screw and open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries into each unit following the
5 5
5