VTech KidiGo NexTag Instruction Manual page 4

Pull out the packaging locks and discard.
ASSEMBLY INSTRUCTIONS
With the KidiGo™ NexTag™, safety comes
first. Adult assembly is required. For your child's
safety, do not let them play with this toy until it
is fully assembled.
1. First, remove the Battery Cover. Install the
batteries into each unit.(See Battery Removal
and Installation section below for detailed
instructions.)
2. Next, slide the tail of the Arm Band through
the Arm Band Slot. Be sure to keep the top
of the buckle on the outside so it faces the top
of the KidiGo™ NexTag™ Unit.
3. Then, pull the end of the tail through the other
Arm Band Slot and over.
4. Slide the battery cover under the strap and
secure it in place before tightening the Arm
Band.
4 4
4