Table of Contents
Advertisement
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
Environmental Phenomena
Static electricity may cause the KidiGo™ NexTag™ to malfunction.
In cases where KidiGo™ NexTag™ is malfunctioning due to static
electricity, reset the system by pressing and holding the Power Button
for 10 seconds until the unit turns on again. Or remove and reinstall
the batteries. In the unlikely event of an electrostatic discharge, the
unit may malfunction and lose memory, requiring the user to reset the
device by removing and reinstalling the batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and filling out
our Contact Us form located under the Customer Support link.
Creating and developing VTech products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of our
products. However, errors sometimes can occur. It is important for
you to know that we stand behind our products and encourage you
to contact us with any problems and/or suggestions you might have.
A service representative will be happy to help you.
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
15
15
15
Advertisement
Table of Contents
