Hunter 42660-01 Installation And Operation Manual page 14

8 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
8-15. To uninstall the light fixture, first disconnect the plug connectors
between the black wire and the black/white wire.
8-16. Disconnect the plug connectors between the two white
wires.
8-17. Uninstall the connector and washer from the end of the
light fixture inside the lower switch housing.
8-18. Unscrew the threaded rod of the light fixture from the
lower switch housing.
8-19. Remove the light fixture from the lower switch housing
pulling disconnected wires through the hole in the
center of the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other
plug connector (female) through the hole.
8-20. Install the dummy terminals (included in the sack parts)
on the two disconnected wires in the lower switch
housing.
8-21. Install the switch housing cap and plug button to the
lower switch housing.
8-22. Once you have uninstalled the light fixture, continue
with step 8-6.
Female Dummy
Terminal
Male Dummy
Terminal
42660-01 • 01/30/08 • Hunter Fan Company
Steps 8-17 – 8-19
Cap
Plug Button
14
Lower Switch
Housing
Threaded Rod
Step 8-21