Assembling And Hanging The Fan - Hunter 42656-01 Owner's Manual And Installation Manual

Standard or Angled Mounting
Steps 3-2 – 3-3
Set Screw
3 • Assembling the Fan
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan.
For Standard or Angled mounting:
Downrod
3-2. Insert the downrod through the canopy and canopy trim ring.
Feed the wires from the fan through the downrod on one side of
the pin in the ball.
Canopy 3-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
Canopy
normal. Securely retighten the set screw with a wrench or pliers.
Trim Ring
Go to 4 • Hanging and Wiring the Fan.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
6
42656-01 • 08/14/09 • Hunter Fan Company