Hunter 42406-01 Owner's Manual And Installation Manual page 12

7 • Completing Your Installation With or Without a Light Fixture (Continued)
Uninstalling the Light Fixture
1. To uninstall the light fixture, first disconnect the plug connectors
between the black wire and the red wire.
2. Disconnect the plug connectors between the two white wires.
3. Uninstall the nut and washer from the end of the light fixture inside
the lower switch housing.
4. Unscrew the threaded rod of the light fixture from the lower switch
housing.
5. Remove the light fixture from the lower switch housing pulling
disconnected wires through the hole in the center of the lower switch
housing.
Note: When removing the wires, pull the thin plug connector (male)
through first, and then pull the other plug connector (female) through
the hole.
6. Install the dummy terminals (included in the sack parts) on the two
disconnected wires in the lower switch housing.
12
7. Install the switch housing cap and plug button to the lower switch
housing.
Hunter Fan Company
Male Dummy
Terminal
Female Dummy
Terminal
Threaded Rod
Cap
Plug Button
Lower Switch
Housing
Steps 3 - 5
Step 7
42406-01 • 20080926