Wall Mount Applications - Johnson Controls F4-XPM Series Installation Manual

Figure 3: Expansion Module mounting position
Mounting features and dimensions
Figure 4: Back of XPM04060 and XPM18000 expansion
module
Figure 5: Back of XPM09090 expansion module
Note:
• Mounting dimensions are listed in millimeters in
the above figures.
• The DIN rail channel and the mounting clips are
shown in an extended position.
DIN rail mount applications
About this task:
To mount a XPM expansion module horizontally on a
35 mm DIN rail (recommended method), complete the
following steps:
1. Securely mount a 20 cm (8 in.) or longer section
of 35 mm DIN rail horizontal and centered in
the desired space so that the expansion module
mounts in the horizontal position.
2. Pull the two bottom mounting clips outward from
the expansion module to the extended position
(Figure 3).
3. Hang the expansion module on the DIN rail by
the hooks at the top of the (DIN rail) channel on
the back of the expansion module (Figure 4), and
position the expansion module snugly against the
DIN rail.
4. Push the bottom mounting clips inward (up) to
secure the expansion module on the DIN rail.
5. To remove the expansion module from the DIN rail,
pull the bottom mounting clips out to the extended
position and carefully lift the expansion module off
the DIN rail.

Wall mount applications

About this task:
To mount a XPM expansion module directly on a wall or
other flat vertical surface, complete the following steps:
1. Pull the two bottom mounting clips outward and
ensure they are locked in the extended position.
2. Determine the proper mounting position the
expansion module will be installed. Mark the
mounting hole locations on the wall using the
dimensions for the expansion module listed in
Mounting features and
hold the expansion module up to the wall or
surface in a proper mount position and mark the
hole locations through the mounting clips.
3. Drill holes in the wall or surface at the marked
locations, and insert appropriate wall anchors in the
holes (if necessary).
4. Hold the expansion module in place, and insert
the screws through the mounting clips and into
the holes (or anchors). Carefully tighten all of the
screws.
Important: Do not over-tighten the mounting
screws. Over-tightening the screws may
damage the mounting clips.
Wiring
Observe the following guidelines when wiring an XPM
expansion module:
F4-XPM Expansion Modules Installation Guide
dimensions. Alternatively,
3