Table of Contents
Advertisement
Table continued from last page
Problem/error
Cause
•
Laundry not
dried or drying
takes too long.
•
•
•
•
•
Unevenly
dried laundry.
•
A slight hitting
noise appears.
•
The door
opens during
drying.
Filters are not clean.
Dryer is placed in a closed room;
room that is too cold; or room
that is too small and the air
overheats as a result.
Laundry was not sufficiently
wrung or spun.
Amount of laundry dried in the
appliance is too large or
insufficient.
Laundry (such as bedding) gets
tangled into large balls.
Laundry of varying types and
thickness, and excessive amount
of laundry.
If the dryer is out of use for a
long period of time, the same
points of load-bearing elements
or components are under stress
for a long time, causing
temporary deformation.
Excessive load on the door (too
much laundry in the drum).
Errors
What to do?
•
Clean the filters (see chapter
"CLEANING AND MAINTENANCE").
•
Make sure there is adequate supply of
fresh air to the dryer; for example, open
the door and/or window.
•
Check if the temperature in the room
where the dryer is installed is too high
or too low.
•
If the load is still wet after completed
drying cycle, an appropriate drying
program should be run again (after
cleaning filters).
•
Use a suitable program or extra
functions.
•
Close the buttons or zippers on the
laundry before drying. Select a suitable
program.
•
After the drying process, loosen the
laundry and select an additional drying
program (e.g. timed drying program).
•
Make sure you have sorted the laundry
by type and thickness, whether you have
added a suitable amount of laundry to
the drum, and whether you have
selected a suitable program.
•
The noise will subside without any
intervention.
•
Reduce the amount of laundry.
what to do?
41
Advertisement
Table of Contents
