Drivers Installation - Gigabyte Z370 HD3P User Manual

please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure CSM Support under the
2. Go to
you want to enable the Optane
Port 21 to
to
3. Enter the operating system, launch the Intel
enable Intel ® Optane ™ Memory on the Intel
4. If you install more than one Optane
5. Follow the on-screen instruction to continue the installation and then restart the system when completed.
™
An Optane memory cannot be used to accelerate an M.2 PCIe SSD.
If more than one Optane
SATA-based boot drive. The other(s) can only be used as data drive(s).
Do not abruptly remove the Optane
functioning correctly.
If you want to change/remove the Optane
After enabling the Optane
3-3

Drivers Installation

After installing the operating system, insert the motherboard driver disk into your optical drive. Click
install. You can click the
the arrow icon to individually install the drivers you need.
Please visit GIGABYTE's website for
more software information.
and make sure
™ memory installed in the M2Q_32G connector, set
; to enable the Optane ™ memory installed in the M2A_32G connector, set PCIe
.
®
® ™ Memory screen.
™ memory, please select which one you are going to use.
™ memory is installed, you can select only one of them to accelerate your
™
memory. Doing so will cause the operating system to stop
™ memory, you must disable it using the Intel
™
™
memory, the related BIOS settings will remain even after a BIOS update.
- 41 -
menu is disabled.
is disabled. If
Please visit GIGABYTE's website
software.
®