Samsung WF906 Series Service Manual page 25

Part
Heater
Figure Description
1. Separate the Back Cover.
2. Separate the Connection Housing (3).
3. Remove the wire vinyl. (1)
4. Separate Connection Housing.
5. Remove then nut holding the heater in
place and then separate out the heater.
Use box Drivers (Socket size: 10mm)
6. Remove the Heater from the Tub.
Caution
Make sure to insert
the Heater into the
correct position of
the bracket inside
the Tub when
reassembling it.
Otherwise, there is a
danger of a fire.
Make sure to push the Tub inwards until the
packing part comes into the Tub completely
when reassembling.
Fasten the holding nut with a force of 5Kgf/ cm2.
If the nut is not fastened properly, there is a
danger of water leaking.
Disassembly and Reassembly _ 23