Samsung WF906 Series Service Manual page 18

Part
Cover-Back
Belt
UNIVERSAL MOTOR
16 _ Disassembly and Reassembly
Figure
2
1
Description
Unfasten the 4 screws that hold the back cover
in place. Remove the back cover by sliding it
down.
(When assembling, slide the back cover up.)
1. Remove the Cover back .
2. Separate the belt and then assembly it.
3. Check if the belt position is at the center of
the Pulley.
Assembling the belt
Place the belt around the Motor-Pulley
(①) and then over the Pulley (②).
1. Separate the Wire Housing from the motor.
2. Remove the bolts holding the motor at the
back of the washing machine.
3. Separate the motor.
Caution
When installing the Belt around the Motor
Pulley, the bottom of the belt must be
located on the second tooth of the motor
pulley.