Central Machinery METAL CUTTING BANDSAW 93762 Set Up And Operating Instructions Manual page 23

5. to lubricate the worm gear and
worm shaft: The Worm Gear (17)
and Gear Shaft (19) run in an oil bath
Gear Box and should not require an
oil change more than once a year,
unless the oil becomes contaminated
or a leak occurs due to improper
replacement of the Gear Box Cover
(14). To change oil in the Gear Box:
a. Position the Body Frame (60) in the
horizontal position. (see Figure s.)
gear boX
cover (14)
bolt (11)
gear shaFt
(19)
Figure w
b. Remove the four Hex Bolts (11),
Gear Box Cover (14), and Gear Box
Gasket (15). (see Figure w.)
c. Remove the old oil from inside the
Gear Box and replace the oil us-
ing 140 weight gear oil. The new
oil should just come to the edge of
the Gear Box. Do not overfill. (see
Figure w.)
d. Replace the Gear Box Gasket (15),
Gear Box Cover (14), and four Hex
Bolts (11). (see Figure w.)
SKU 93762
heX
worm
gear (17)
For technical questions, please call 1-800-444-3353.
6. to clean the exterior parts of the
bandsaw, use only a clean cloth
and mild detergent or mild solvent to
clean the body of the Saw. do not
immerse any electrical part of the
machine in any liquids.
pivot (120)
Figure X
7. when the bandsaw is not in use or
when transporting the tool: Al-
ways lower the Body Frame (60) to
its horizontal position and insert the
Locking Pin (115) into the Pivot (120)
to secure the Body Frame in place.
(see Figure X.)
8. caution! all maintenance,
service, or repairs not mentioned
in this manual must only be per-
formed by a qualified service tech-
nician.
locKing pin (115)
Page 23