Table of Contents
Advertisement
2
Terminal Interfaces
Terminal ID
If your interface is not a standard PC AT, refer to
"Supported Terminals" on page
2-2
through
page
2-3, and locate the Terminal ID number for your PC. Scan the
Terminal ID bar code below, then scan the numeric bar code(s) from the
Programming Chart
inside the back cover of this manual to program the scanner
for your terminal ID. Scan Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID bar code, then 0, 0, 3 from the
Programming Chart
inside the back
cover of this manual, then Save. If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the
Programming
Chart, scan
the Terminal ID bar code, scan the digits, and the Save code again.
Note: The default interface for the IT2020-5 is Keyboard Wedge (Term ID =
003).
Terminal ID
Save
Note: After scanning one of these codes, you must power cycle your computer.
IMAGETEAM™ 2020/5620 System Manual
2 - 1
Advertisement
Table of Contents
