Brother GTXpro Quick User Manual page 9

WEEKLY MAINTENANCE: Suction Cap Cleaning
Suction Cap Cleaning
WEEKLY MAINTENANCE: Exhaust Cap & Lances
The four extrusion lances and the 2 holes [see in the blue circle] are located adjacent to the suction
caps at the Exhaust position. They need to be cleaned and free of dried ink. Always clean the first
hole at the front and go backward while cleaning the lances, carefully finishing with the last hole.
Exhaust Cleaning
WEEKLY MAINTENANCE: Wiper Cleaning
Cleaning top of wiper
If a more thorough cleaning is required, refer to removal of wiper in the instruction manual for a detailed cleaning.
The black silicone lips of the two suction caps should be
cleaned with the Cleaning Stick T dipped in Cleaning Solution.
It is necessary to remove the build-up of excess ink located on
the edges of the caps. It will prevent air leakage and maintain
optimal suction of the pumps. Be careful not to touch the foam.
Keep it flat.
Direction to clean
Cleaning under the
teeth on side of wiper
Cleaning Stick T
Four extrusion lances
Both white plastic wipers [White &
CMYK] should be cleaned on both
sides and tops with the Cleaning
Stick T dipped in Cleaning Solution.
Use the tip of the Cleaning Stick T
to clean under the teeth of the wiper
holder and remove the dried ink.
Be sure to use the Cleaning Stick T
separately for white ink and color ink.
9