Brother GTXpro Quick User Manual page 11

Simply remove the old Wiper Cleaner by lifting it up. Replace with a new one.
> When removing and replacing of the Flushing Foam, DO NOT forget to wash and clean the receivers
to avoid ink build up. It is very critical to avoid clogging the ink path to the waste tank.
Wiper Cleaner Replacement
Flushing Foam Replacement
Lift up the Flushing Foam Receivers
and place them on paper towels to
soak up the dripping ink. Remove
the two Flushing Foam pieces and
wash the receivers to clean off
excess ink build up. Install new
Foam and put the receivers back in
their original location.
Fan Filter Replacement
Remove the 2 filter holders from the
rear top of the machine and remove
the dirty filters. Mount a new Fan
Filter in each of the black frames.
The Coarse mesh surface goes in
the direction of the inner side of the
printer and the fine mesh surface
goes in the direction of the outside
of the printer.
11