Table of Contents
Advertisement
Installing heat sink assembly
1. Align the heat sink assembly with screw holders on the system board.
2. Replace the M2.0 x 2.5 screws to secure the heat sink to the system board.
NOTE:
Tighten the screws on the system board in the order of the callout numbers [1, 2, 3, 4] as indicated on the heat
sink.
3. Install the shielding covers on the heat sink assembly.
NOTE:
Affix the black tape / copper tape that secure the IR camera cable for model shipped with IR camera (optional).
4. Affix the conductive tapes to secure the shielding covers.
5. Replace the shielding covers to cover the heat sink assembly.
NOTE:
The shield covers can break if not handled carefully.
6. Install the:
a.
display panel
b.
uSIM/microSD card
NOTE:
uSIM card is installed only on tablets shipping with WWAN module.
7. Follow the procedure in
Front facing camera
Removing front camera
1. Follow the procedure in
28
Using your tablet
After working inside your tablet
Before working inside your
tablet.
Advertisement
Table of Contents
