Panasonic KX-TG2711C Operating Instructions Manual page 34

Useful Information
Answering system
Problem
The unit does not record new
messages.
I cannot operate the answering
system remotely.
Liquid damage
Problem
Liquid or other form of moisture
has entered the handset/base
unit.
Caution:
R To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Registering a handset to the base unit
1
Handset:
MMENUN
2
MbN: "Initial setting" a MOKN
3
MbN: "Registration" a MOKN
4
MbN: "HS registration" a MOKN
5
Base unit:
Proceed with the operation for your model.
n KX-TG2711 series: page 3
Press and hold M
n KX-TG2721 series: page 3:
Press and hold M
34
Cause/solution
R The answering system is turned off. Turn it on (page 23).
R The message memory is full. Erase unnecessary
messages (page 24).
R If you subscribe to a Voice Mail service, messages are
recorded by your service provider/telephone company,
not your telephone. Change the unit's number of rings
setting or contact your service provider/telephone
company (page 27).
R The remote access code is not set. Set the remote
access code (page 25).
R You are entering the wrong remote access code. If you
have forgotten your remote access code, enter the
remote access code setting to check your current code
(page 25).
R The answering system is turned off. Turn it on (page 26).
Cause/solution
R Disconnect the AC adaptor and telephone line cord from
the base unit. Remove the batteries from the handset and
leave to dry for at least 3 days. After the handset/base
unit are completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and charge fully
before use. If the unit does not work properly, contact an
authorized service centre.
N (LOCATOR) for about 5 seconds. (No registration tone)
N (LOCATOR) for about 5 seconds until the registration tone sounds.