Firmware Update 固件更新 - PRESONUS AudioBox GO Owner's Manual

Sample Rate. Changes the sample rate
You can set the sample rate to 44.1, 48, 88.2, or 96
kHz. A higher sample rate will increase the fidelity
of the recording but will increase the file size and
the amount of system resources necessary to pro-
cess the audio.
采样率。改变采样率
你可以将采样率设置为44.1、48、88.2 或 96kHz。
较高的采样率将提高录音的保真度，但会增加文件
的大小和处理音频所需的系统资源量。
Block Size. Sets the buffer size.
From this menu, you can set the buffer size. Lower-
ing the buffer size will lower latency; however, this
will also increase performance demands on your
computer. In general, you will want to set the buffer
size as low as your system can safely support. If
you begin to hear pops, clicks, or distortion in your
audio path, try raising the buffer size.
块大小。设置缓冲区的大小。
在这个菜单中，你可以设置缓冲区的大小。降低缓
冲区的大小会降低延迟；但是，这也会增加对计算
机的性能要求。一般来说，你想把缓冲区的大小设
置到你的系统可以安全支持的最低限度。如果你开
始听到音频路径中的爆音、咔嗒声或失真，请尝试
提高缓冲区大小。
3.3 Firmware update 固件升级
After you've installed Universal Control and con-
nected your AudioBox GO, you may be prompted
to update The AudioBox GO firmware. Updating
your firmware is a quick process, just click on the
green "Update Firmware" button and Universal
Control will do the rest.
Do not disconnect your AudioBox GO during the
firmware update process. Once the firmware is
updated, your AudioBox GO is ready to... GO!
当你安装了 Universal Control 并连接了
AudioBox GO 后，你可能会被提示更新
AudioBox GO 的固件。更新你的固件是一个快速
的过程，只需点击绿色的 "更新固件 " 按钮，
Universal Control 将完成其余的工作。
在固件更新过程中，请不要断开 AudioBox GO
的连接。一旦固件更新完毕，你的 AudioBox GO
就可以开始了！
3.3 Firmware update 11