Gianni Industries Electromechanical Lock Installation Instructions

Installation Instructions
62mm cylinder for max •42mm door leaf
72mm cylinder for max •52mm door leaf
ø5.0
28
250
124
150
28
ø5.0
1 2
ø5.0
Alignment CL
ø5.0
Align the center line (CL) of the
lock body template with the CL of
Cut out mortise holes for the lock
the door leaf. Ensure the CL of the
body and strike plate and drill holes
strike plate template matches the lock
according to the templates.
body CL as closely as possible.
5 6
Connect power cable to the lock
Attach the cover plates for the
and test before screwing to the
cylinder lock
door leaf.
Copyright © All Rights Reserved. P-MU-ML-300 Ver. H Publish: 2010.12.24
Unit:mm
Door Loop
(Optional)
The door loop protects the wiring
from damage at the door hinge.
Attention! Please ensure that the
direction of the template is correct
3 4
Tighten the fixing lugs with Drill and cut the hole for the lock
screws.
cylinders as shown in the template.
7 8
Install the cylinder
Fix the strike plate.
ML-300
ML-300-SW
Specification
Operating Voltage» ML-300: 12 or 24VDC
ML-300-SW: 12~24VDC/AC
Voltage Tolerance» ±10%
Current Draw» ML-300: 280mA/12VDC; 140mA/24VDC
ML-300-SW: 210mA/12VDC; 150mA/24VDC
Version Changeable» Fail-safe or Fail-secure
Operating Temperature» -10~45°C
Humidity» 0~95% non-condensing
Lock bolt sensor switch output» SPDT rated 3A/125VAC
Solenoid testing» Tested to 1,000,000 cycles
Net Weight» ML-300: 800g / ML-300-SW: 815g
Just applicable to vertical installation
Packing Contents
Fixing Lug
Allen wrench (1.6mm)
NIB
Lock bolt
Strike Plate
For double swing door For single swing door
Version Changeable:
Take out the Screw 1 , release screw 2 , move the
position and then tighten both screws.
"Fail-Safe"
(Power to Lock)
Caution:
Do not completely remove screw 2 (as marked in the figure)
as the interior solenoid might fall off.
4 - 4
Copyright © All Rights Reserved. P-MU-ML-300 Ver. H Publish: 2010.12.24
Electromechanical Lock
Installation Instruction
Double Swing Doors
Double swing door Outswing
Stud bolt Position
For fail-safe mode
Euro profile
key cylinder
For fail-secure mode
"Fail-Secure"
(Power to Open)
Inswing
4 -1